TCS Patch Binder
Surface Preparation: Surface must be cleaned entirely of dust, dirt and debris. Brush a thin coat of TCS Patch Binder in the dry, clean low spot and allow to dry before application of the patching mix. This acts as a primer. All repairs must be flush and smooth to adjoining surfaces for optimum results. New asphalt must cure 30 days prior to application. New concrete must cure 28 days prior to application.
Mixing Procedures: A heavy duty power mixer (drill with mixing attachment or mortar mixer) is recommended.
For patching and filling depressions, use the following mix design
Acrylic Patch Binder...............1 gallon
Sand (40 - 60 mesh)................30 lbs.
Cement....................................6-7 lbs.
(Thoroughly mix dry sand and cement together before adding to TCS Patch Binder.)
Application: Apply patching mix with smooth sided screed or trowel. Be sure to feather edges on patches. TCS Patch Binder patching mix should be applied in multiple lifts to achieve desired depth in patches greater than 1/2”. Use surface scraper or floor sander to tidy ridges of patch edges before completely dried.
Important: Mix thoroughly for only 2 to 4 minutes. DO NOT OVERMIX as this may cause excessive air entrainment and loss of strength. Temperatures must be a minimum of 50ºF and rising both during application and for a period of at least 24 hours after applications. Do not apply when rain is forecast within 24 hours. Keep from freezing. Close container when not in use.
Coverage: One gallon will produce enough patch mix (when mixed with sand and cement) to fill .86 square yard (approximately 7.75 square feet) at
1/4” depth.
When used as a Crack Filler: One gallon will produce enough material to fill 75-150 lineal feet of crack, depending on depth and width of crack.
Drying Time: Allow patch to harden completely before applying coatings or opening to foot or vehicle traffic.
VOC: This material contains less than 150 grams of volatile organic compounds per liter.
Caution: KEEP FROM FREEZING. KEEP OUT OF REACH OF CHILDREN. Do not take internally. If swallowed, call a physician immediately. In case of contact with eyes, flush immediately with water for 15 minutes and call a physician. Do not apply when rain is imminent. When not in use, keep container tightly closed and upright to prevent leakage. Do not store in direct sunlight or above 100 ºF. In case of spillage, absorb and dispose of in accordance with Federal, State and Local regulations.
Warranty: The statements made on this label are believed to be true and accurate and are intended to provide a guide for approved application practices. As workmanship, weather, construction, equipment utilized and other variables affecting results are all beyond our control. Tennis Court Supply warrants only that the material conforms to product specifications and any liability to the buyer or use of this product is limited to the replacement value of the product only. In no event shall tennis court supply be liable for any injury, loss or damage, either direct or incidental, special or consequential, however arising in connection with material or
equipment furnished or work performed. Tennis Court Supply shall not, in any manner, be liable for any defects, variations or change in condition in the substructure over which its products are installed.
