Description: TCS Crack Mastic is a 100% acrylic, rubberized emulsion, designed for sealing cracks up to 1/2” wide on asphalt and concrete sport surfaces. Available in red, green, or neutral.

Surface Preparation: Cracks must be cleaned and free of dust, dirt, debris, and vegetation. Deep cracks may be filled with sand or foam backer rod to up to ¾” below the surface prior to application of TCS Crack Mastic.

Mixing Procedures: Stir thoroughly before using.

Application: Work TCS Crack Mastic down into crack using a trowel or putty knife until crack is filled completely. Smooth material at surface level with damp rag or trowel to assure smooth finish with surrounding surface area.

Important: Temperatures must be a minimum of 50ºF and rising both during application and for a period of at least 24 hours after application. Do not apply when rain is imminent in the forecast. Keep from freezing. Close container when not in use.

Coverage: Typically, one gallon will fill approximately 75-150 feet of cracks depending on depth and width of crack.

Drying Time: Drying time is dependent upon temperature, humidity and filler thickness. Note: wet conditions, including sub-surface moisture, can create drying problems with crack fillers. For best results, allow adequate time after rains for the sub-surface and surrounding ground to dry out before application of TCS Acrylic Crack Filler.

VOC: This material contains less than 150 grams of volatile organic compounds per liter.

Caution: KEEP FROM FREEZING. KEEP OUT OF REACH OF CHILDREN.  Do not take internally. If swallowed, call a physician immediately. In case of contact with eyes, flush immediately with water for 15 minutes and call a physician. Do not apply when rain is imminent. When not in use, keep container tightly closed and upright to prevent leakage. Do not store in
direct sunlight or above 100 ºF. In case of spillage, absorb and dispose of in accordance with Federal, State and Local regulations.

Warranty: The statements made on this label are believed to be true and accurate and are intended to provide a guide for approved application practices. As workmanship, weather, construction, equipment utilized and other variables affecting results are all beyond our control. Tennis Court Supply warrants only that the material conforms to product specifications and any liability to the buyer or use of this product is limited to the replacement value of the product only. In no event shall tennis court
supply be liable for any injury, loss or damage, either direct or incidental, special or consequential, however arising in connection with material or equipment furnished or work performed. Tennis Court Supply shall not, in any manner, be liable for any defects, variations or change in condition in the substructure over which its products are installed.