SURFACE PREPARATION
Pavement
surface must be cleaned entirely of dust, dirt, debris and all loose
materials. Repair of pavement surface defects, depressions and cracks
must be completed prior to application. All repairs must be flush and
smooth to adjoining surfaces.
New asphalt
surfaces must cure 14 to 30 days prior to application. It is recommended
to apply Acrylic Resurfacer (Technical Bulletin CMT3) as required by
surface roughness and porosity to provide a smooth, dense underlayment
for application of color texture and finish coats.
New
concrete surfaces must cure 28 days prior to application. Concrete
surfaces should have a medium broom finish or similar roughened texture.
They must never be steel trowelled. Etch surface with Muriatic or
Phosphoric Acid and apply TCS Concrete Primer/Bonder prior to color
coating.
MIXING PROCEDURES
Court Color Base is ready to use. Do not add water. Stir thoroughly prior to
application. A power drill and paddle mixer are recommended.
APPLICATION
Apply Court Color Base with a soft rubber squeegee. Allow each coat to
thoroughly dry before applying the next coat. Two coats are
recommended.
IMPORTANT
Surface
and air temperatures must be above 50°F (10°C) during application and
for at least 24 hours after application. Stir before using. Do not apply
when rain is imminent or forecast. Keep from freezing. Close container
when not in use.
COVERAGE
Approximately .12 to .15 gallon per square yard per Coat (90-100 Square Feet per gallon, per coat).
DRYING TIME
Court Color Base dries in 30 to 60 minutes under optimum drying conditions. Allow 48 hours before allowing foot traffic or play.
CAUTIONS
Do
not store in direct sunlight or where temperatures exceed 100°F. Do not
apply if rain is imminent or forecast. Keep from freezing. Close
container when not in use. Refer to product Safety Data Sheet (SDS) for
additional safety information and precautions.
WARRANTY
The
statements made on this technical bulletin are believed to be true and
accurate, and are intended to provide a guide for approved construction
practices. Manufacturer does not make, nor does it authorize any agent
or representative to make any warranty, express or implied, concerning
this material as workmanship, weather, construction, equipment utilized
and other variables affecting results are all beyond our control.
Manufacturer warrants only that the material conforms to product
specifications and any liability to the buyer or user of this product is
limited to the replacement value of the product only. In no event shall
Manufacturer be liable for any injury, loss or damage, either direct or
incidental, special or consequential, however arising, in connection
with material or equipment furnished or work performed. Manufacturer
shall not, in any
manner, be liable for any defects, variations or change in condition in the substructure over which its products are installed.
