SURFACE PREPARATION
Pavement surface must be cleaned entirely of dust, dirt, debris and all loose materials. Repair of pavement surface defects, depressions and cracks must be completed prior to application. All repairs must be flush and smooth to adjoining surfaces.
New asphalt surfaces must cure 14 to 30 days prior to application. It is recommended to apply Acrylic Resurfacer (Technical Bulletin CMT3) as required by surface roughness and porosity to provide a smooth, dense underlayment for application of color texture and finish coats.
New concrete surfaces must cure 28 days prior to application. Concrete surfaces should have a medium broom finish or similar roughened texture. They must never be steel trowelled. Etch surface with Muriatic or Phosphoric Acid and apply TCS Concrete Primer/Bonder prior to color coating.
MIXING PROCEDURES
PickleMaster RTU is ready to use. Do not add water. Stir thoroughly prior to application. A power drill and paddle mixer are recommended.
APPLICATION
Apply PickleMaster RTU with a soft rubber squeegee. Allow each coat to thoroughly dry before applying the next coat. Two coats are recommended.
IMPORTANT
Surface and air temperatures must be above 50°F (10°C) during application and for at least 24 hours after application. Stir before using. Do not apply when rain is imminent or forecast. Keep from freezing. Close container when not in use.
COVERAGE
Approximately .12 to .15 gallon per square yard per Coat (60-75 Square Feet per gallon, per coat).
DRYING TIME
PickleMaster RTU dries in 30 to 60 minutes under optimum drying conditions. Allow 48 hours before allowing foot traffic or play.
CAUTIONS
Do not store in direct sunlight or where temperatures exceed 100°F. Do not apply if rain is imminent or forecast. Keep from freezing. Close container when not in use. Refer to product Safety Data Sheet (SDS) for additional safety information and precautions.
WARRANTY
The statements made on this technical bulletin are believed to be true and accurate, and are intended to provide a guide for approved construction practices. Manufacturer does not make, nor does it authorize any agent or representative to make any warranty, express or implied, concerning this material as workmanship, weather, construction, equipment utilized and other variables affecting results are all beyond our control. Manufacturer warrants only that the material conforms to product specifications and any liability to the buyer or user of this product is limited to the replacement value of the product only. In no event shall Manufacturer be liable for any injury, loss or damage, either direct or incidental, special or consequential, however arising, in connection with material or equipment furnished or work performed. Manufacturer shall not, in any
manner, be liable for any defects, variations or change in condition in the substructure over which its products are installed.
